Thursday 17 May 2012
  • Increase font size
  • Default font size
  • Decrease font size
  • default style
  • blue style
  • green style
  • red style
  • orange style
Print

VRF-2, VRF-4, VRF-HP, VRF-P VELOUR FIBERS

Written by Super User. Posted in MSDS SHEETS

SECTION I - PRODUCT  IDENTIFICATION

 

Product  Name:  VRF-2, VRF-4, VRF-HP, VRF-P  VELOUR FIBERS                                             

Revision:  12/2000         

SECTION  II - HAZARDOUS INGREDIENTS & OTHER COMPONENTS

INGREDIENT CHEMICAL NAME

OSHA PEL

ACGIH TLV

OTHER LIMITS RECOMMENDED

CAS NUMBER

Titanium Dioxide

N/A

N/A

N/A

13463-67-2

Nylon 6,6 Polyamide

N/A

N/A

N/A

32131-17-2

Water, Absorbed

N/A

N/A

N/A

7732-18-5

SECTION  III  – PHYSICAL DATA / CONTENTS WITHOUT PROPELLENT

BOILING POINT:

N/A

SPECIFIC GRAVITY (H2O=1):

1.14@20/20°C

VAPOR PRESSURE (mm Hg):

N/A

MELTING POINT:

250°C

VAPOR DENSITY (AIR = 1): 

N/A

EVAPORATION RATE (Butyl Acetate = 1):

N/A

SOLUBILITY IN WATER:

Soluble in conc. Formic acid.  Not soluble in water, alcohol, xylene, benzene, acetone.

APPEARANCE AND ODOR:

N/A

                     

 

SECTION IV: FIRE AND EXPLOSION  HAZARD DATA

 

FLASH POINT (METHOD USED):

325°C

FLAMMABLE LIMITS

N/A

EXTINGUISHING MEDIA:

WATER FOG  x

STANDARD FOAM 

CO2

 

DRY CHEMICAL 

HALON 

 

UNUSUAL FIRE AND EXPLOSION HAZARDS:

Firefighters and others who may be exposed to products of combustion should wear full protective equipment including self-contained breathing apparatus.  Fire fighting equipment should be thoroughly decontaminated after use.

SPECIAL PRECAUTIONARY STATEMENTS:

N/A

 

SECTION V: REACTIVITY DATA

STABILITY: 

x Stable  Unstable

Incompatibility :

N/A

Hazardous Decomposition:

Hazardous gases/vapors produced are carbon monoxide, ammonia, traces of hydrogen cyanide antioxides of nitrogen.

HAZARDOUS POLYMERIZATION:     

May Occur   xWill not occur

Conditions to Avoid:

Avoid packing or storage at temperatures above 80°C (176°F)

SECTION  VI: HEALTH HAZARD DATA

ROUTES OF ENTRY & HEALTH  HAZARDS (ACUTE AND CHRONIC)

INGESTION:  

Essentially nontoxic an inert.

EYES:                  

Dust may cause mechanical irritation.

INHALATION:       

Dust may produce mechanical irritation of the mucous membranes of the nose, throat, and upper respiratory tract.

SKIN:

None expected or likely under normal conditions of use.

EMERGENCY AND FIRST AID  PROCEDURES

INGESTION:

No special precautions necessary.

EYES:

Treat as a nuisance dust hazard.  Flush eyes with water for 15 minutes.  If irritation persists, obtain medical attention.

INHALATION:

Remove to fresh air.  Other measures are usually unnecessary.  If irritation persists, obtain medical attention.

SKIN:

Treat as a nuisance dust hazard.  Flush contaminated skin with soap and water.  If irritation persists, obtain medical attention.

 

SECTION VII: PRECAUTIONS FOR  SAFE HANDLING AND USE

STEPS TO BE TAKEN IN CASE LARGE AMOUNTS ARE RELEASED:

Reclaim for processing if possible.

WASTE DISPOSAL METHOD:

Material is not a “hazardous waste” as defined in 40CFR 261; therefore, disposal is permitted by landfill or by incineration.  Comply with local, state, and federal regulations.

PRECAUTIONS TO BE TAKEN IN HANDLING AND STORAGE:

Avoid extreme conditions of heat and humidity.  Avoid dust accumulation.  Store boxes and bales in accordance with good materials handling practices.

OTHER PRECAUTIONS:

N/A

 

SECTION VIII: CONTROL MEASURES

RESPIRATORY PROTECTION:

Avoid breathing dust.  Use NIOSH/MSHA approved equipment when airborne exposure is excessive.  Respiratory protection must comply with 29 CFR 1910.134.

VENTILATION:

Local and general exhaust ventilation should be used as needed to prevent irritation and avoid dust accumulation.

LOCAL EXHAUST:

N/A

PROTECTIVE GLOVES:

None normally required.  However, good safety and industrial hygiene practices should be followed.

EYE PROTECTION:

None normally required.  However, good safety and industrial hygiene practices should be followed.

 

SECTION IX: SPECIAL  PRECAUTIONS

HEALTH:

HAZARD RATING KEY

FLAMMABILITY:

0 = MINIMAL

REACTIVITY:

1 = SLIGHT

PERSONALPROTECTION:

2 = MODERATE

 

3 = SERIOUS

 

4 = SEVERE

 

* = CHRONIC HEALTH EFFECTS

Disclaimer:  The  information contained herein is based on the data available to us and is  believed to be accurate.  However, no warranty is expressed or implied regarding  the accuracy of this data or the results to be obtained from the use thereof. We  assume no responsibility for injuries from the use of the product described  herein.

Subscribe

We invite you to subscribe to receive our news bulletins that will contain announcements of new products, training, pecials and other vital information to help you become more profitable in your business. Please take this opportunity to subscribe. Don't miss out on an important new product announcement or a training date!

"On Sale"

Prices effective through 03/30/2012 P/N DESCRIPTION SPECIAL FCPA-A Carpet Protector Adhesive 8.39 BFG Black Flex Grip— Great for Plastics 4.87 Delta 9 Healight Sealant 39.96 FHT Fitzgerald’s Heat Torch 49.00 6082 Aerosol Velour Spray Adhesive 9.31 VT44 4 Pack, Graining PAPERS 6.91 GC-4 4 oz Graining Compound 7.59

Training & Products

Call 800.441.3326 for more information on our next training seminar.” NEW AT FITZGERALD'S See our new products.